Clash of Clans Key Holder
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Clash of Clans Key Holder
Published 2015-01-26T13:30:29+00:00
I thought that when brought into three dimensions the Clash of Clans shield would make an interesting keyholder.
Using the arrows fired into the shield as hooks to throw your keys over.
I designed the keyholder in Solidworks basing the main shield on a picture of the clash of clans logo found in a google image search. The arrows were made to match the logo as closely as possible, then re-sized to allow a keyring to fit over them.
I judged the angle to fit the arrows into the shield as a mix between what looked right on the logo and what would allow the shield to be printed off support free.
I added two screw hooks to the back of the shield so that it could be slotted onto the wall and held in place by two screws.
The shield was printed in PLA using a 0.2mm layer resolution.
Print the shield back down on the print bed.
Turn off support material as the shield will print completely support free!
Date published | 26/01/2015 |
Time to do | 180 - 360 minutes |
Material Quantity | 46 grams |
Dimensions | 100mm x 100mm x 90mm |
Complexity | Very Easy |
Support Free | YES |