1/2 (half) Inch and 3/4 (three quarter) Inch Threaded Electrical Junction Box Plugs
1/2 (half) Inch and 3/4 (three quarter) Inch Threaded Electrical Junction Box Plugs
3D
Published 2018-05-29T14:12:27+00:00
This is a threaded plug (cap) for electrical junction boxes. There are both 1/2-inch and 3/4-inch versions as well as versions that include a hex thumb screw for easy tightening/loosening (which I highly recommend--who wants to carry around a huge flat-head screwdriver just for plugs?).
Note: I highly recommend using some dielectric grease on the threads to ensure water can't get into your electrical box.
Remember: In order to comply with the National Electrical Code (NEC) you'll have to print this in a flame-retardant filament and protect it from UV rays somehow (either by using UV-stable filament or painting with a UV-protective coating).
Print flat (no rotation) @0.2mm resolution with 3 perimeters and it should work out fine. The threads are slightly under-sized to make for an easy fit. If you find the plugs are still too tight just adjust the "diameter" value down a bit in the included .scad file (say, -0.005 or -0.01).
| 发表的日期 | 29/05/2018 |
| 让时间去下载 | 5 - 10 分钟 |
| 材料数量 | 1.37 grams |
| 尺寸大小 | 23mm x 23mm x 8mm |
| 支持自定义 | YES |