3D-PRINTING-NERD SPOOL HOLDER V3
3D-PRINTING-NERD SPOOL HOLDER V3
Published 2018-07-20T16:40:17+00:00
Hello,
This is my 3rd Design for the 3DPN-Spool-Holder Design Challenge! Just a simple & elegant Thing! :)
You will find all the parts already arranged in the 3dpn-spool-holder-v3.stl file !
I did not have any 3/4 inch wood so I used some aluminium rods I had laying around :)
I know this isn´t the most creative piece of art but it is functional, very rigid, and is entirely 3D-printable! It doesnt take up much space in your shelf, however, if you are searching for a more simple design, then you should check out my 2nd Design, because it is way more simple but it doesn't look as nice as this one! :) it requieres a bit of support but it shouldn't be a problem. If you have your bridge-settings dialed in you can even try printing without supports but it requieres those next level bridges. Note that the outer rings do not need support. I modelled this in Fusion360 and I really learned a lot designing these parts!
Hope you enjoy :)
发表的日期 | 20/07/2018 |
让时间去下载 | 300 - 450 分钟 |
材料数量 | 75-100g |
尺寸大小 | 130x190x26 mm |
打印工艺 | FDM |
复杂程度 | 容易 |