Adjustable Nintendo Switch Stand - With USB Cable notch and air vent holes
Adjustable Nintendo Switch Stand - With USB Cable notch and air vent holes
Published 2017-03-27T09:28:34+00:00
This is a remix of Snuffypot11's fantastic Switch stand found here: https://www.myminifactory.com/object/nintendo-switch-adjustable-stand-30162
I love this stand but did not love that the USB cable couldn't be routed out the back, or that the air vents on the back of the unit got blocked. This is the same stand with a notch taken from the base so the cable can be threaded out of the back of the unit, and has air holes in the holder to allow the Switch to breathe a bit better.
Print the same way as the original, 0.2mm layer height, I did 15% infill on the base, 100% on the small pin, and 40% on the bigger pin and the holder just to make sure the Switch is safe, and full supports on the holder piece. Also seems to work great as a phone stand when the Switch isn't on it, makes for a really great all-around dock/stand you can keep at your desk!
发表的日期 | 27/03/2017 |
让时间去下载 | - 300 分钟 |
材料数量 | 55 grams |
打印工艺 | FDM |
复杂程度 | 中级 |