Please enter the code below
These masks were captured using Autodesk's 123d Catch software. I've flattened the bottoms and added a recessed screw catch in each for easy wall hanging.
I printed both without support and it turned out fine. Mask1 has a weird overhang and resulted in a little spaghetti in one small area but I just cut it off with an exacto and all was well.
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
AfricanMaskwallhangingset! by mikebattaglia is licensed undert he Attribution - Non-Commercial - ShareAlike license.