Agent Bracelet
Agent Bracelet
3D
Published 2017-09-11T13:43:52+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
A simple bracelet which can look pretty nice when polished and painted.
But behold! Because those who wear this bracelet could be very secret agents, carrying up to two micro SD cards per bracelet containing very secretive secrets!
Or maybe they just need some extra gigabytes for picture and video storage.. Which does not exclude that they are secret agents!
Made for fun. Print it if you'd like and enjoy! ;)
I made the model simple enough if someone would like to do some modding. (It's easier to do the modding to the original in Vectary)
This model was created with VECTARY - the free, online 3D modeling tool
Credits:
I've modeled the top of the SD card slots to be 45 degree slopes, so print the model as is.
Because of this it doesn't necessarily need support, but I would recommend enabling the support generation for the outer perimeter at the bottom of the bracelet. It won't be much extra filament.
Do not scale it, because the micro SD slots will also scale. If you need bigger or smaller then you'll need to modify the model.
I recommend a minimum 1 mm wall width.
Calculated the minimum and maximum print times with 20% infill density, and 0.125 mm - 0.25 mm layer height.
| 发表的日期 | 11/09/2017 |
| 让时间去下载 | 60 - 180 分钟 |
| 材料数量 | ~20 grams |
| 尺寸大小 | 770x640x300 mm |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |
