Apple Watch charging base - Macintosh Design
Apple Watch charging base - Macintosh Design
Published 2017-11-27T10:11:43+00:00
Fits apple watch and charger. I did not make this i got it off of thingiverse just look up apple watch dock on thingiverse and there it is with more designs.
The two parts should be separated in the slicer such that the outer case can be printed upside down. This reduces support requirements greatly. This is a moderate print with some fine details, support is required. Support removal is not difficult but care should be taken not to over stress that parts as it is removed. After printing the sliding surfaces should be sanded slightly to remove roughness; that is the slide slots inside the outer case and the rails at the edges of the interior piece. The puck holder should also be sanded to that the puck fits easily inside the holder. If the puck is too tight the holder will crack. Finally, the cable guide at the bottom rear is very tight and some adjustment to it will probably be required. None of this is difficult but will ensure smooth operation.
发表的日期 | 27/11/2017 |
让时间去下载 | 150 - 200 分钟 |
材料数量 | 36 grams |
尺寸大小 | 51x44x60 mm |
打印工艺 | FDM |
复杂程度 | 容易 |