Audio Technica ATH-910 PRO headset earcup holder repair
Audio Technica ATH-910 PRO headset earcup holder repair
3D
Published 2018-06-19T18:12:42+00:00
This is a couple of repair parts for the Audio Technica ATH-910 PRO headset. The files include the main earcup holder and the tiny clasp used in the back to hold it onto the main pin. These pieces will work on either side.
I recommend a decently solid amount of infill, as you want this piece to be somewhat strong. Because it is so thin, I also think 0.1 mm layer height is the way to go, but my prototypes at 0.2 mm were decently strong as well.
You need the support under the pins, but if you put support everywhere, it will fill in the hole for the pin and clasp. It is possible to pull this support out in more or less one piece, but you'll need small pliers. If you think your printer can handle bridging the rectangular gap, just support the pins.
| 发表的日期 | 19/06/2018 |