Auto Coin Sorter for All Currencies
Auto Coin Sorter for All Currencies
3D
Published 2017-03-22T09:50:06+00:00
An automatic coin sorter for many currencies. See also http://youtu.be/7F2fIF9PNBk for a short demo video.
To store a coin, you may release a coin from the rightmost top, and it will slide down the hill and go into the right tube. To get a coin, you may pull the whole rack out and take out any coin.
These instructions below are especially for Ultimaker2 printer and Cura software. Please adjust any parameter as needed if you are using other software.
-
Use 'normal' quality. Or if you're an export, consider using the settings provided below.
-
Print the top board
???-Sorter-topboard.stl.- Cura expert settings:
-
- Layer height = 0.1mm,
-
- Shell thickness = 2.4mm,
-
- Bottom/top thickness = 1.5mm.
- Print!
-
Print the base box
???-Sorter-box.stl.- Cura expert settings:
-
- Layer height = 0.1mm,
-
- Shell thickness = Bottom/top thickness = 1.2mm.
- Tune retraction settings at the printer:
-
- Retraction length = 3mm.
- Print!
-
Print the tubes
???-Sorter-tubes.stl. Same settings as step 3. - Put them together. Done!
| 发表的日期 | 22/03/2017 |