Bell Siphon for Aquaponic
Bell Siphon for Aquaponic
Published 2018-11-10T03:12:15+00:00
You can use any software, just need support on the side tube (you can print with no supports, but have chances to leak, just need to seal, I recommend using Silicone). The 3.0 version is prettier and more resistant, but need a good bridging.
UPDATE: New version 4.0, the side tube is smaller, so can be printed better with less risk of leaking and no support at all!!
New Update: Fixed the problem in the 5.0 version where the flow rate become linear, so all the water that comes to the grow bed passes directly back, stopping making the tide.
Você pode utilizar qualquer Software, apenas necessário suporte no tubo lateral (porém também imprime sem, porém cuidado com vazamentos, você pode selar depois com silicone por exemplo) A versão 3.0 é mais bonita e resistênte, porém sua impressora precisa ser boa com pontes.
Atualização: Nova versão 4.0, tubo de respiro menor, menor risco de vazamentos e sem necessidade de suportes!!
Nova Atualização: Consertado o problema na versão 5.0 onde o fluxo se tornava linear e passava direto pela cama de plantio, parando de fazer a maré.
发表的日期 | 10/11/2018 |
让时间去下载 | 5 - 10 分钟 |
材料数量 | 35g |
尺寸大小 | 40x45x125 mm |
支持自定义 | YES |