BondTech BMG/ V6/ Volcano direct drive for Creality Printers
BondTech BMG/ V6/ Volcano direct drive for Creality Printers
3D
Published 2018-12-07T22:42:16+00:00
This is a CFD optimised mounting and part cooling solution for direct drive installation of the BondTech BMG extruder and V6 hot end to Creality printers that utilise the standard Creality X carriage.
With good bridging, all parts print with no support. Otherwise minimal support is required for the mounting plate. Check the images for the correct orientation of the duct.
There is sufficient vertical adjustment of the part cooling duct to permit the use of either standard V6 or Volcano heater blocks.
30/12/18: Mount modified to accommodate changes made by the manufacturer to the X carriage. Compatible with both old and newer parts.
9/02/19: BLTouch and EZABL mounts modified to suit the thicker mount plate.
| 发表的日期 | 07/12/2018 |
| 支持自定义 | YES |
Mounting diagram for Bondtech BMG and e3d v6, can accommodate Volcano as well.