BTT TFT35 V2.0 Enclosure
BTT TFT35 V2.0 Enclosure
3D
Published 2020-10-16T04:35:27+00:00
This is my version of a tidy enclosure for the BTT TFT35 v2.0.
The design features the following:
- Fixings for 3x M3 nuts on the back housing to which you could attach the provided flat mount or design and use your own mount.
- Thinning of rear housing opposite ports if you want to just connect a single cable or cables.
- Three thinned circles through which you could route multiple cables if required
- Front housing that covers edges the edges of the LCD panel and retains access to the reset button.
- recess for the SD card slot area to aid access.
Hardware required for the enclosure
4x M3 20mm bolts (Design is sized for hex key varieties)
4x M3 hex nuts for enclosure
3x M3 hex nuts for rear mount points
3x M3 10mm bolts (Design is sized for hex key varieties)
Optional extras
4x m3 rubber washers (1/2mm thick) - used to limit any minimal movement of display within enclosure.
Assembly
Place 3 hex nuts in recesses inside the bottom of the enclosure. Seat them in place using bolts from other side to pull in if required.
Fit three caps over the nuts to ensure they do not fall loose in the housing.
cut out / remove any thinned areas as required to plug in cables to suit your intended use.
place enclosure bottom with back showing and install 4 x M3 nuts (use bolt from other side to pull in if required).
Turn bottom over. Install washers on 4 screw locations.
Place the display unit (LCD facing up). Remove protective LCD covering if present.
Place the Top part over the display, line up display and case sides and install 4x M3 20mm bolts through top housing, display and bottom housing. Bolts may protrude fractionally once tightened.
Screw in the flat mounting if required or design and print your own mount if you prefer.
Send me tips if you feel like it and have money to spare but seeing it in use by anyone other than me is exciting in itself :)
Also if you have suggestions for mounting options let me know and I'll consider whether I can make them. If you make any mounting options yourselves and want them linked from my enclosure description please give me the details and I'll likely post the link to your design.
Printed 0.2mm layer heights with 0.4mm nozzle.
Some screw holes will be obstructed by a single layer of filament. This is done so that support material is not required when printing.
The layer can be broken through from the shortest side to clear the screw hole. This can be done fairly easily with a small drill bit, knife or other such tool.
Brim can help with adhesion. Print may still be usable with a millimetre or two of lift in one or more corners on the top or bottom section. If there is any evidence of pressure on the LCD when tightening, the lift is probably too much and you should not continue to prevent any damage to the unit.
Similarly if features do not line up when trying to fit the display make sure you have the correct display unit and version of the display unit. In my case I found the microswitch for reset had been mounted in a tilted position so I had to refit it flush with the circuit board to have the button in the correct reference position.
| 发表的日期 | 16/10/2020 |
| 让时间去下载 | 4 - 分钟 |
| 尺寸大小 | 116mm x 66mm x 20mm (excluding mount) |
| 支持自定义 | YES |