Cannon from Castle of Buedingen
Cannon from Castle of Buedingen
3D
Published 2017-10-23T17:10:11+00:00
50 years ago I saw a cannon at the castle of Buedingen in Germany. After I took several photographs I built a model of it made from steel and wood. To make it more decorative I designed the metal fittings a little bit ornate.
Some time ago I went to see the cannon again for further details it wasn't there anymore. So I can't say what type and what size it was.
After I uploaded the naval cannon I also wanted to design this one, but I didn't know how to make proper printable wheels.
The only way I found, is to make them in the same way as in reality. But the spokes where still a problem, until I decided to split them in half.
The most realistic way is to make the felloe from 6 segments. If you want to use the complete felloe in one piece you must take the split hub. So you can first put all spokes into the felloe and then push the two half hubs together.
In order to make all parts to be printed, I had to make some changes.
The only things you have to get are:
3 mm x 190mm shaft from brass for the axle. You can flatten the ends with a hammer. Then drill a 1,5 mm hole.
Some nails and needles to fasten the fittings.
3 threaded rods M3 x 56mm with nuts.
1 rod 3mm diameter x 49mm
Recommended print settings for Slic3r
spiral vase mode, 1 perimeter, width =0.4mm layer hight =0.3mm, no infill
axle band
axle band large
hub band small
hub band large
2 perimeter, width =0.4mm, layer hight =0.3mm, no infill
tire solid
3 perimeter, width =0.4mm, layer hight =0.15mm, 2 solid bottom layer, 3 solid top layer, 30% infill
spokes
2 perimeter, width =0.4mm, layer hight =0.2mm, 2 solid bottom layer, 3 solid top layer, 25% infill
hub
hub half
felloe segment
felloe complete
axle top
axle bottom
1 perimeter, width =0.38mm, layer hight =0.2mm, no solid layer needed, 20% infill
spacer hub
2 perimeter, width =0.5mm, layer hight =0.3mm, 2 solid bottom layer, 4 solid top layer, 15% infill cheek
cheek
crossbar back
crossbar middle
crossbar front
1 perimeter, width =0.4mm, layer hight =0.2mm, no solid layer needed, no infill
fitting front
fitting back
1 perimeter, width =0.5mm, layer hight =0.2mm, no solid layer needed, no infill
top clamp
2 perimeter, width =0.38mm, layer hight =0.2mm, 2 solid bottom layer, 2 solid top layer, no infill needed
plates all
1 perimeter, width =0.35mm, layer hight =0.1mm, 2 solid bottom layer, 2 solid top layer, 30% infill
eyelet
ring 1.9 5
1 perimeter, width =0.5mm, layer hight =0.2mm, no solid layer needed, no infill
eyelet clamp
There are two parts I could only slice with Cura properly
shell thickness = 0.4mm, layer hight = 0.2 mm, infill 100%
tire brim
latch brim
| 发表的日期 | 23/10/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |
| 支持自定义 | YES |