Carla and LEO's Sheep
Featured
5,740
views
540
downloads
5
collections
0 comments
Loading comments... 
Carla and LEO's Sheep
3D
Published 2017-02-13T15:57:25+00:00
70
0
Add to Collection
Description
From the book LEO the Maker Prince:
http://www.leothemakerprince.com
http://www.amazon.com/LEO-Maker-Prince-Journeys-Printing/dp/1457183145
LEO said, "Draw me a sheep", and Carla did. The next thing you know, his nozzles heated up and his spools started spinning, and this is the sheep that emerged on this tray.
Instructions
- Print the sheepWHITE file (sparse fill is OK).
- Print the sheepBLACK file. (The upright version is newest and may print well without support.)
- Clean support off of all files and insert the black parts into the white part. There is a nose, ears, and four legs.
- Note that the legs should bend towards the inside of the body.
Here's a tip from Jen Adams at MakerBot: if you put the legs in most of the way (remember, they should curve inwards) and then put the sheep on a table surface and press gently down on the body, you can get the legs to snap in and fit snugly.
Technical Information
| 发表的日期 | 13/02/2017 |
| 打印工艺 | FDM |
More Information
Object Parts