cAT-hAT
cAT-hAT
3D
Published 2017-10-02T09:28:33+00:00
Description
I made this because my husband thought that the AT-AT model I made should have cat ears and a hat. I thought it would be a fun joke that would take a few hours but I ended up taking over a month. It has been a good project to learn about articulating joints and 3d printing in general.
It is not a perfect model and I may work on it in the future. The sockets are prone to breakage. If you make this, please let me know any suggestions you have for improvement!
Print quantity
4x foot
4x lower leg
4x leg socket
3x tail (As pictured. More or fewer to make tail longer / shorter.)
1x everything else
Instructions
Snaps together. No gluing necessary, unless you want the hat to stay on permanently. Filing may be needed on head socket and tail ball pegs depending on how you print it.
Support material will need to be generated.
High infill recommended on the head ball and tail socket pieces to reduce likelihood of breakage.
Model shown printed on Prusa i3 MK2S using PETG (with terrible first layers).
| 发表的日期 | 02/10/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |