CB adapter for wanhao duplicator and clones.
CB adapter for wanhao duplicator and clones.
3D
Published 2017-08-10T14:12:05+00:00
Well I thought I did not need to edit this thing, however I was wrong. You can actually fit the fan inside of the control box as well. I may do a video covering this on its own. most of the insulation is the same as the method I already listed. So if you want to push or suck air, you can do both.
This is a small and simple adapter made to attach a 75X75X30 blowerfan to the control box of the wanhao duplicator and it's various clones. To my knowledge they have not changed the box on the clones or the new 2.1 printers. I know the plus removes the box entirely.
I have done a 12 hour print test with the new fan installed, along with smaller prints. I can feel a slight bit of air flow through the holes on the side of the box, however it's pretty faint.
Printer brand : Wanhao
Printer : Wanhao Duplicator i3 V2
Rafts : Doesn't Matter
Supports : Doesn't Matter
Resolution : .2
Infill : 12
Notes : This took around 50 minuets for me to print
| 发表的日期 | 10/08/2017 |
