Cheshire Cat - MMU
Cheshire Cat - MMU
3D
Published 2019-06-27T17:04:12+00:00
MMU version of the Cheshire Cat from Alice and Wonderland
In order to make this model mostly support free, this is a two piece model (head, body) that require gluing together. It should be noted that the head by itself sits well and does not require the body.
The height of the assembled model is 70mm.
This MMU model was derived from my non-MMU model (reworked for a clean MMU print):
https://www.myminifactory.com/object/3d-print-cheshire-cat-22830
Enjoy, and don't forget to post your makes!
Prusa Slicer 2.0 was used with the default .2mm profile and Generic PLA filament settings.
I used a small support block under the hands to ensure a clean print.
Print times for me:
Head alone: 4hr 10min
Body alone: 11hr 32min
All parts at the same time: 13hr 46min
Paramount filament colors used, in order of filament number:
1- Black
2- White
3- Harajuku Pink
4- Simpson Yellow
5- Decepticon Purple
Extra Notes
There are two 3MF files attached. One for just the head and one for the body. The head is just over a four hour print and can be used by itself.
I've also included all the STL files in the proper positioning.
All the supplied files are for the smallest recommended size of the model. The model can be sized up without issue, but I would not recommend sizing it down any further.
| 发表的日期 | 27/06/2019 |
