Climbing Trainer Hangboard
Climbing Trainer Hangboard
Published 2018-12-10T14:12:11+00:00
I did this design a while back and only posted it now because I finally found a god place for it. You got multiple ways to grip it from easy round ones to very thin ones and even a slope. I screwed mine to a wooden board (I made some fittings inside the part that exactly hold some nuts to reenvorce the fit), which is screwed to the wall. You want at least 2 cm distance from the grip to the wall, else you can‘t grip around the top! Feel free to leave your feedback in the comments and post photos of your final part, I highly appreciated that.
You want to use thick walls, at least 4, more is better, if the very bottom wall is completely solid you should be alright, that is the weakes part in my opinion. Same is for the top and bottom. Infill you should have at least 20%. Use supports on the round part, it may get a bit rough but that should be alright.
发表的日期 | 10/12/2018 |
Late reply but I wanted to get my printer ready for these bad boys. Thanks for the info and I hope more people print this awesome hangboard if you ever make another training part I’ll gladly test it. Hope to keep seeing stuff from you. Great work!!!