Clown Specks
2,346
views
54
downloads
2
collections
0 comments
Loading comments...
Clown Specks
3D
Published 2017-10-16T09:05:42+00:00
3
0
Add to Collection
Description
This object was made in Tinkercad. https://www.tinkercad.com/things/a1MLvhfu7nt
Printing Details
The only part of this print that requires supports are the posts. The front frame printed fine without supports. I glued the front post holders in the slots on the back of the front frame with epoxy. Super glue will probably work as well. Make sure you sand the post so they fit into the post holders snuggly but not to loose. Also, sand the inside edge were the nose bridge is so it's a little more rounded. This makes it less irrirating to your nose. Have fun!!!
Technical Information
发表的日期 | 16/10/2017 |
打印工艺 | FDM |
复杂程度 | 容易 |
More Information
Object Parts