Cobra B.A.T. chest from the 80's G.I. Joe Action Force show


Cobra B.A.T. chest from the 80's G.I. Joe Action Force show
Published 2014-09-29T19:52:01+00:00
Here a 3D printable Cobra B.A.T. chest from the 80's G.I. Joe show. This design was made with Tinkercad.
The Battle Android Trooper (B.A.T.) is a fictional robot from the G.I. Joe: A Real American Hero universe. BATs are the perfect Cobra trooper. They never question orders, shirk duty or surrender. They are cheap and easy to replace. However, BATs do not react well to changes in field conditions, or discriminate well between targets. They will shoot at anything that moves. Cobra Infantrymen don't like to be on the same battlefield with B.A.Ts, and will sometimes dispense BATs into a losing battle, by kicking them out of low-flying aircraft without parachutes. B.A.Ts also have a tendency to burst into flame when hit from behind
Print at 00.2mm layer height, with 50% infill. This takes 194 minutes and uses 41.8 g of filament.
发表的日期 | 29/09/2014 |
让时间去下载 | 194 - 194 分钟 |
材料数量 | 41.8 g |
尺寸大小 | 91.7mm x 91.7mm x 15.2mm |
复杂程度 | 容易 |