Compact Hemera Mounts for 40mm fan, 18mm and 12mm probes, filament sensor, and HyperCube carriage
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Compact Hemera Mounts for 40mm fan, 18mm and 12mm probes, filament sensor, and HyperCube carriage
This is a set of mounts I designed for mounting the Hemera to my HyperCube build.
The blower fan and probe mounts should be compatible with any other printer if you'd like to mix it with another carriage design.
Included parts:
* 12mm probe mount.
* 18mm probe mount, e.g. the EZABL.
* Filament sensor mount, with holes for optionally attaching an drag chain. Also included text for multi-material printing.
* 40mm print cooling fan mount. This part sits very close to the heat block, printing in ASA/ABS is recommended! PETG also probably works, but I haven't tested it.
* Carriage mount for the original HyperCube. I can probably figure out EVO mounting holes if there's interest.
M3 screws needed: 6mm x2 (probe), 8mm x 4 (blower), 10mm x4 (carriage), 25mm x2 (filament sensor)
Status | Rejected |
支持自定义 | YES |