CR10 - CR10S - Ender 3 x-limit switch and filament runout mod for direct drive
CR10 - CR10S - Ender 3 x-limit switch and filament runout mod for direct drive
3D
Published 2019-07-12T18:17:44+00:00
This is a bracket to hold the X axis motor, the X limit switch and the filament run-out sensor for the Creality CR10S, CR10 and the Ender 3. It was made to accommodate a direct drive modification.
To complete the assembly you will need four M3x40 screws, two M3x12, one 7 mm ball, one PTFE 1.75 quick connector.
This design is built upon the X limit bracket shared on Creality GitHub page.
I have made this mod for the Bondech DIrect Drive Extruder & Hotend upgrade kit. Recent CR10S batches seem to be delivered with the Ender 3 bracket, in the past spacer screws were used. This mod can replace either one or the other.
2019-07-24
New iteration V3 provides better loading and unloading filament guide.
Update 2019-07-17
There is a new iteration called V2 which add a fillet to enter the filament more easily.
Both pieces work well in my experience however the V2 should be an improvement.
This model was designed to be printed without support. Raft might help for printing the second part of this model.
| 发表的日期 | 12/07/2019 |
| 支持自定义 | YES |