Daisy - Flat flower
14,367
views
1,929
downloads
21
collections
3 comments
Loading comments... 
Daisy - Flat flower
3D
Published 2017-03-20T11:37:16+00:00
236
3
Add to Collection
Description
I had some success with the production of leaves using this method and wanted to see if it could be applied to flowers. Assemble all parts. Then, heat the petals and bend them. I've also found this is a good way to burn your fingers, so be careful.
"Flower Petal 1.stl" and "Flower Petal 2.stl" are not the same. One of each will need to be printed.
"Flower Stem.stl" will need to be printed twice.
You may need to add a Brim to the stem.
Technical Information
| 发表的日期 | 20/03/2017 |
| 让时间去下载 | - 360 分钟 |
| 尺寸大小 | 300, 100, 100 |
| 打印工艺 | FDM |
| 复杂程度 | 困难 |
More Information
Object Parts
I decided to skip the leaves and had to make a tweak to the top of the flower (the original STL did not have a hole in the flower petal center file (used meshmixer to create a hole that would fit the stem) so it is all just friction fitted. No glue needed. I then just scaled the stem to be as long as I needed and the results are as you see. Awesome work, thank you so much! Gave them as a mothers day gift.