Darth Vader Lamp
Darth Vader Lamp
3D
Published 2015-11-19T12:20:13+00:00
Hi there,
This is my Darth Vader inspired lamp.
I used a typo LED light which comes in two in a box for $19 Australian
I used Darth Vader black filament of course and about 3 hours in I changed the roll for a little bit of red then I went back to the black.
That touch is up to you but I think it brings the devil out of the lamp with that colour.
There is also a little cylinder which I glue to the end of the typo light which has a battery compartment near the bulb.
the light turns on when you pull the cord so i thought I would feed the light from underneath and the cylinder works as a stopper if you want it that way.
Otherwise have nothing, the hole is a tight fit so I had to warm up the lamp hole with boiling water then I fitted the typo light and its tight in there now.
I hope you enjoy it.
when you make it make sure to add photos.
thank you!!
| 发表的日期 | 19/11/2015 |
| 打印工艺 | FDM |