Death Star 2
Death Star 2
Published 2018-02-09T11:52:52+00:00
Star Wars Death Star 2. I've found a lot of printable designs, but the nicest needed to be paid for. So I tried out some stuff and came up with this. I printed the Death Star files at 20% scale and the Stand at 100% scale. When finished printing the interior I kept some of the support behind on the print because, lets face it, the Death Star was under construction and leaving the support in the print for the most part, just gave it a better effect. Since this is my first design, please leave me some feedback.
Scale the interior to 20% and print draft quality
Scale the exterior to 20% and print draft quality
The stand is 100% scale and printed in draft except for the logo and text. This was printed in normal mode.
发表的日期 | 09/02/2018 |
让时间去下载 | - 3000 分钟 |
打印工艺 | FDM |
复杂程度 | 容易 |
It was a moderate print which I printed around 4'' and I should of gone bigger so the parts would be a lot stronger and thicker. But I managed after a few tries on printing the internals.