Dell Latitude E-Docking Spacer
3,295
views
73
downloads
0 comments
Loading comments...
Dell Latitude E-Docking Spacer
3D
Published 2018-05-03T12:51:24+00:00
5
0
Add to Collection
Description
This is a replacement for the following:
http://www.dell.com/en-us/shop/dell-latitude-e-docking-spacer/apd/452-bbtr/pc-accessories
It is used for smaller laptops (eg. Latitude 5000 series) that dont take up all the space on the dock.
Printing Details
Printed at 0.2mm. If you print it upside down, you only need a some supports for the tab that comes out at the front. Otherwise, you can print it the right way up with supports inside, then just leave the supports in when its done (which will make it a bit stronger too). You'll just need to remove the supports from the two small areas with the semi-circle shapes.
Technical Information
发表的日期 | 03/05/2018 |
打印工艺 | FDM |
复杂程度 | 容易 |
More Information
Object Parts