DIY Motorized and Remote Controlled UNO DSL Dolly
DIY Motorized and Remote Controlled UNO DSL Dolly
3D
Published 2018-09-21T09:05:51+00:00
This is the first version of my remote controlled DSLR Dolly.
Very easy to print as it doesn't require support. PLA should work as no strain is put on the parts. You can see the build instructions here: https://www.youtube.com/watch?v=hhJ2yv65Dhg
Thing syou will need:
Elegoo Uno or similar: http://geni.us/AmaznUno or http://geni.us/BGUno
EasyDriver: http://geni.us/BGEasy or http://geni.us/AmazEasy
Ir Remote and Sensor: http://geni.us/BGRemote or http://geni.us/AmazRemote
Power Supply: http://geni.us/ArduinoPS or http://geni.us/AmazPSU
Pancake Motor: http://geni.us/MotorSlim
Dolly: http://geni.us/DSLRDolly
you'll also need some screws and nuts:
2 x M3 nuts
2 x M3x18 (I said M3x12 by mistake in the video)
7 x M3x8
2 x M2x1
3 x M3x28 (flat head)
Sketch and Schematics: http://geni.us/Sketch
Sketch to get remote codes: http://www.circuitbasics.com/arduino-ir-remote-receiver-tutorial/
| 发表的日期 | 21/09/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |