earrings holder 3
earrings holder 3
3D
Published 2017-09-15T11:31:24+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
A flower to hold earrings. Great for bedside table so you can see and choose your earrings. Petals can even hold your rings or just for dumping earrings quickly (when its dark!). This is the third iteration, with each iteration being the result of feedback from a usability tester.
At 60% (recommended print size), earring holes are 2mm diameter and bounding box is 97.5 x 97.8 x 79.4 mm, with print time about 7 hours 25 minutes.
Full size is 166.8 x 166.5 x 133.4 mm, and takes about 20.5 hours to print. (See screen images for Cura setup.)
Being printed on Cocoon, in translucent purple ABS (photo shows about 70% printed).
This model was created with VECTARY - the free, online 3D modeling tool
Credits:
Print at 60% size for about 100mm across petals.
| 发表的日期 | 15/09/2017 |
| 材料数量 | 90 grams ABS |
| 尺寸大小 | 97.5 x 97.8 x 79.4 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
