Easy Folding Phone Stand

A sturdy folding phone stand that sets up easily, locks in place, and collapses quickly to a slim 12mm. It also raises the phone high enough to allow a charging cord to be attached.

 Instructions:
Print with infill of 10%. Use 1.75mm filament or thin hanger wire cut to length for hinge pins. A drop of superglue at either end will hold the pins in place.

Individual pieces are included for printers with smaller build plates.

 To set up the stand, push on the catch to release the halves. Push out the brace through the front opening and seat it in the slot in the base. Push up the shelf through the bottom hole and pull it through the front opening. Push the shelf down to lock the stand in its open position.