Edit Thing Garmin Cup Holder Mount
Edit Thing Garmin Cup Holder Mount
3D
Published 2015-04-21T11:04:13+00:00
Quick and to the Point. This is just a quick little mount that allows you to move your Garmin Nuvi off of you windshield. Personally I really hate having my field of view blocked, and glancing down to see the map is no harder than looking somewhere else. Even better than that, my new truck has 5 cup holders in the front. Yup, thats not an exaggeration. The new Dodge 2500 Pickup has 2 in the lower console, and 3 more in the seat console. If I actually tried to drink that much, I would never make it out of town without having to stop 5 times for... well, you get the point.
I printed both without supports and they tested very well. Depending on your printer you may need to add supports to the angled one, but it was not needed using my MakerBot Rep2. The photo shows the unit without any cleanup
Print at 0.2 mm layer height, with 10% infill. This uses 148 g of filament and takes 19 hours and 17 minutes.
| 发表的日期 | 21/04/2015 |
| 让时间去下载 | 1157 - 1167 分钟 |
| 材料数量 | 148 g |
| 尺寸大小 | multiple parts |
| 复杂程度 | 容易 |