Freewheel Beadlock Rim 1.9
Freewheel Beadlock Rim 1.9
3D
Published 2017-02-02T18:43:09+00:00
I whipped up this wheel so that I could mount some 1.9 crawler tyres on the front of my RC hot rod for a dirt outing. This version has significant negative offset (rear bearing face is flush with the rear edge of the rim)
For assembly of one wheel you need:
(5) M2x12 mm screws
(5) M2 nuts
(2) 5x11x4 bearings/bushings (common in tamiya buggies)
You may want to scale the ring slightly, either to make it larger diameter, or wider, but since this is a freewheel I haven't had any issues yet.
Please note the CC-Attribution license, you are welcome to sell prints of this design, you only need to credit me (either link to this page, my webpage http://www.ossum.co.za or my facebook page https://www.facebook.com/ossumdesigns )
| 发表的日期 | 02/02/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |
Came out great!