Friendship Bracelet Clip
Friendship Bracelet Clip
Published 2018-11-30T13:03:31+00:00
I know, I know, friendship bracelets are supposed to stay tied on your wrist forever. But, you know what's super convenient? When you can remove them when you want. I designed this clip so I could make bracelets for people in the future, giving them the option to take them off they want to. These things work super well too. To learn more on how to use them, check out this tutorial:
https://www.braceletbook.com/tutorials/67_adding-paracord-buckles-to-friendship-bracelets/
If you make sure you have a good first layer, these aren't that hard to print. I use supports but honestly, it is struggle sometimes to remove them from the female side so I would recommend trying to print without any and pray the bridging goes well. Or print the female side of the clip on it's narrow edge without supports. I'll give that a try in the future.
Print at 0.15 or 0.2 mm layer height
Make sure you have good first layer adhesion being that they are so small
Try to avoid supports on the inside of the female side
发表的日期 | 30/11/2018 |
让时间去下载 | 10 - 20 分钟 |
打印工艺 | FDM |
复杂程度 | 容易 |