Ghostbusters Logo - Dual Extrude
Ghostbusters Logo - Dual Extrude
3D
Published 2015-07-04T11:04:07+00:00
A small project i worked on for my first attempt atbeing a creator and not just a printer. Used a logo from google and put into Selva3.com to get the logo and had a friend,Chris Thompson make small tweaks for me and then arranged on print bed.
Idea was to print the red 'No' sign in red filament and the Ghost section in glow in the dark filament. I also downloaded a Ghostbusters font and have been using that to put names accross the middle bar to personalize the logos for badges, door stickers ect. Only a fun project, not very high res but i've been printing them about 10cm and they look great when done.
In the images shown the red filament ran out before completing the last layer lol. printed at 0.2 layer, medium quality on Makerware.
For the Red ABS i printed at 235c and the Glow in dark at 200c with print bed heated to 100c. 25% infil but need to perhaps alter becasue the lettering didn't come out great.
Hope folk enjoy this and will link to Chris' page once its up as hes a very talented 3D Artist who's work taking a look at
Print at 0.2 mm layer height, with 10% infill. This uses 28 g of filament and takes 3 hours and 53 minutes.
| 发表的日期 | 04/07/2015 |
| 材料数量 | 28g |
| 尺寸大小 | 150 x 130 x 4 mm |
| 复杂程度 | 非常容易 |