Golf Ball Hole
Golf Ball Hole
Published 2018-02-26T12:10:28+00:00
Hello Everyone,
I designed a golf hole to use around my apartment. If I have some time between classes or am just bored, I can pull this out and putt a little without having to go to the course.
This design was inspired by a product from the putter designer, Scotty Cameron. If you miss the hole, the design gives the ball a little track to shoot back to you so it doesn't go rolling away.
I used SolidWorks to model this and I added the files for both the complete hole, as well as two pieces split in halves. The halves have a puzzle piece design that are meant to slide and lock into each other. The hole is the standard 4 1/4" hole which in my opinion looks a little big but if its regulation, sounds good to me!
**There is a little descrepency in the model but it shouldn't come out on the print itself.
Printed on the Dremel 3D20 Idea Builder
Recommended Settings:
- 2 or 3 shells (I do 3 but 2 is enough)
- 20% infill
- No supports needed
Note, print time and material quantity are estimates of my printer (they may vary for others)
发表的日期 | 26/02/2018 |
让时间去下载 | 360 - 420 分钟 |
材料数量 | 115 grams |
尺寸大小 | 222 mm x 200 mm x 29 mm (8.75 in x 7.9 in x 1.15 in) |
打印工艺 | FDM |
复杂程度 | 容易 |
支持自定义 | YES |