Handgrip designed to float in water with a GoPro camera attached (tested with a GoPro Hero3). Designed especially for big hands. It has a hole to insert a safety strap if desired.
It is meant to be printed with ABS as its density is lower (floatability was not tested with PLA).
Nozzle diameter: 0.4 mm (2 perimeters)
Layer height: 0.15 mm
Speeds: 30-40 mm/s
Time: 2:45 to 3:15
Infill: 5-10% (7% in the printing picture)
No supports needed. Brim may be helpful.
Expected weight and volume: 22 grams and 89 cc
Feedback is always welcome. Cheers!
*Exclusive sponsored gift by @Wesup included with this design.