Head phones
Head phones
3D
Published 2014-02-19T17:41:25+00:00
A pair of completely 3D printable headphones - just add electronics. All components are fully customisable, so you can scale to fit your head exactly. Print in whatever colours you choose and start listening to your music in a very unique way, your ears will thank you!
Print The box speakers at the maximum resolutions, 20% infill, minimum support.
all the rest 50% infill, maximum resolution, no support.
Material that you Will need:
-http://www.ebay.co.uk/itm/1-2m-WHITE-3-5mm-Headphone-Jack-to-2-RCA-Phono-Cable-UK-/320621756779
-http://www.ebay.co.uk/itm/Connector-RCA-Phono-Chassis-Panel-Sockets-Stereo-Red-Black-PAIR-03254-/191040549238
-http://www.maplin.co.uk/p/025w-mylar-and-paper-round-speaker-40mm-n94fu
-Semi-stretchable fabric: 2X small 8inch by 8 inch squares of spandex or lycra like fabric.
We knew we were going to be building a few of these sets so we grabbed a yard of material from Fabrics store but an old T-Shirt will also work.
Step1: Weld the two small wires (1cm each) betwenn the speakers and the RCA leads.
Step2: You need to wrap the Semi-stretchable around the plastic halls and glue it, then fit the ring the plastic halls and glue it once again.
Step3: Fit the whole block in to big halls.
Enjoy
| 发表的日期 | 19/02/2014 |
| 材料数量 | n/a |
| 尺寸大小 | 80 200 200 |
| 复杂程度 | 中级 |