Husky Utility Knife handles
Husky Utility Knife handles
3D
Published 2019-01-16T11:54:11+00:00
These are 3D Printed "OUTER" handle covers for an inexpensive utility knife.
Please note- this knife. has and actual solid inner handle and these go OVER it.
**These are in no way to replace a knife's STRUCTURAL handle as the plastic would likely give out and end up hurting you or other!! Please use common sense with items like these!**
There is a back (where the belt clip is) and a front which I have designs with the 3 Fun in the Kuntry Basement folks as well as a blank you can just use as is or import into a 3D editor and add your own logo.
Knife it is designed for is a Husky - Model # 99733 - use caution and remove the blade before starting!!
you will need to drill out and remove the 3 rivets as well as use 2, T-10 star bits, *one on each side,* to remove the main pivot bolt.
Item is designed to replace the 3 rivets with M2 screws and nuts.
Use caution and pay attention when disassembling to orientation of the flat spring, lever and washers on sides of main pivot.
Pre insetting M2 nuts makes assembly easier.
| 发表的日期 | 16/01/2019 |
| 支持自定义 | YES |