This is for using 10MM Igus drylin bushings for the Z-axis bed supports on the Hypercube 3D printer. I wanted a better set of rods than the 8mm used in the original design.
All hardware is 4mm with the screws being 15mm long. You will need to mirror these to make both left and righ side parts. Some minor fitting may be required if your printer does not have good calibration.
This was printed in Natural HIPS with 65% infill. Printed on an UP3D Up! Box+
If you need this printed in ABS, HIPS or some other strong material please contact me.