Ian Wright Spec Design
Ian Wright Spec Design
3D
Published 2017-03-09T20:54:36+00:00
These are Specs made for Ian Wright. Whole design is made and picked according to his face 3D Scan.
There are two main difference in design, Frame and Temple with small gap and without. I was not sure will material become too fragile if there is gap so I kept impression and made two versions.
There is another issue with hinges, guideline shows that there is no cavity in frame for hinges. I was not able to test are hinges works if they are built inside of frame so There are also 2 versions with cavity in frame and without. This leads to cavities in temple because my vision is that gap between frame and temple should be minimum.
I hope you will like it.
Update: Temples ver A and Temples ver B are updated because they were not watertight
| 发表的日期 | 09/03/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |