Jeep Combat Rims 1.55"
Jeep Combat Rims 1.55"
3D
Published 2017-06-18T18:30:10+00:00
These are a set of "Jeep Combat Rims" designed specifically for the Ossum Jeep, but can be used with any 1.55" tyre on any RC that uses a 12mm hub.
These rims were made possible by a user who was kind enough to send me some 1.55" tyres to measure up, so as usual, if you appreciate the work I put into these and would like to seem more free uploads like them, please consider leaving a tip, or at least sharing Ossum with your friends on social media.
These rims were designed to be more true-to-scale, so the beadlocks are accomplished with six M2x6 screws and captive nuts.
There are a number of options for the back of the rim, allowing different offsets - the number of mm in the filename indicates the depth of the protrusion off the back of the rim. The 9mm rim is roughly equivalent to the "extra offset" rims in the orginal jeep build.
I recommend
- 0.1mm layers for the front piece and hub
- 0.2mm layers for the rear and ring piece
- Use support around outside edge
- Make sure the is no support inside the nut recesses, it's really hard to get out!
| 发表的日期 | 18/06/2017 |
| 让时间去下载 | 180 - 360 分钟 |
| 尺寸大小 | 25x25x50 |