Key Condenser
Key Condenser
3D
Published 2016-01-08T19:00:08+00:00
Check out some of my premium designs printed in silver and other metals in my store:
Small plates with space for M3 nuts with holes tappable by 14mm M3 screws (Designed such that these 14mm screws will allow you to hold 4 keys). To setup in g-code software, multiply the part and mirror one of them about the X-axis.
Assembly Instructions:
First screw the M3 screw through one side (into the hole on the largest hexagon) to the point where the tip of the screw is slightly less than the width of 4 keys from the inside surface. place the keys on the screw and place the other printed plate on the other side. Screw the screw that holds the keys' heads in place (top screw) first while tightly squeezing the keys together. Screw in the remaining screws.
| 发表的日期 | 08/01/2016 |
| 让时间去下载 | - 28 分钟 |
| 材料数量 | 5 grams |
| 尺寸大小 | 63mm x 27mm x 6mm |
| 打印工艺 | FDM |
| 支持自定义 | YES |
