Leaf heater switch insert
Leaf heater switch insert
Published 2018-09-21T07:12:28+00:00
This is a switch panel insert for a Nissan Leaf. It allows you to fit a 20 mm diameter round switch into the lower dash switch panel without having to drill any holes.
You'll need to pull open the lower facia to get access to the back of the switch panel, then remove one of the blanks. Then fit the 20 mm round switch into this 3D printed insert. It will friction fit into the lower hole. (The upper switch holes are a different size!)
This is useful if you buy a *Nissan Leaf G1 Range Extender Heater Control Switch* like this one: http://raglanelectricbikes.co.nz/store/#!/Nissan-Leaf-G1-Range-Extender-Heater-Control-Switch/p/86463715/category=0
I also laser printed a black lable and stuck that on. Let me know if you'd like a copy of the PDF for that.
This object was made in Tinkercad. https://www.tinkercad.com/things/hHznzZFAxIo
I printed it in black PLA at 0.2 mm layer hieght.
发表的日期 | 21/09/2018 |
让时间去下载 | 17 - 分钟 |
尺寸大小 | 23 mm x 39 mm |
支持自定义 | YES |