Leaning Tower of Pisa


Leaning Tower of Pisa
Published 2016-05-12T09:38:38+00:00
This is a model of the Leaning Tower of Pisa. You can either print it with a straight base plate and a leaning tower or, and I recommend that, with a rotated base plate with some supports and a straight tower (4 degrees rotated) to make the layers also seem "leaning" at the finished print. That means that the tower stands straight when getting printed.
--PASS/NO PASS-- PASS, I recommend not printing in less than 50 % !!pilars are fragile at 50%!! --support-- Tiny bit support needed at bells --Files-- Print is 1 STL file. No gapps/faults in file (checked with meshmixer) Printed in two halves at 50 % --Printing-- 200 micron layer height Printed with 2 perimeters 20% Infill (honeycomb) 3 Top/bottom layers --Fillament-- White PLA 220 degrees Heated bed 60 degrees --Prints-- 900 Minutes print job 160 Gram --Post printing-- Sanding gluing 2 halves together
发表的日期 | 12/05/2016 |
让时间去下载 | 800 - 1000 分钟 |
材料数量 | 160 |
尺寸大小 | 90x90x240 |
打印工艺 | FDM |
Printed at 0.1mm with a white PLA. Slight warping in the base and many parts are delicate and snap off easily. Still a beautiful design that was fun to print and display.