LED Tape Lighting Bar
LED Tape Lighting Bar
3D
Published 2019-07-18T15:07:13+00:00
I wanted to put some LED lighting on the underside of my bookshelf but didn't want to rely on the self adhesive of the LED tape for a permanent fixture. Additionally, I wanted to make a tidy job of the electrical connections, so I have created a box with lid for the connections and a housing for the LED tape which screws to the underside of the shelving.
The LEDs fit snugly into the shallow trough-like housing with no need to use the adhesive. Each length of housing is just over 200mm long. You will need a start end, finish end and a number of centre pieces to create your desired length of lighting. E.g. I have used a start and finish plus 4 centre pieces to create a lighting bar of 1.2 metres.
I have since printed this using "wood" filament with a 0.6mm nozzle and it worked a treat. It now blends in better with the wooden shelf to which it is attached.
Printer: Ender 3
Material: PETG
Resolution: 0.2mm
Speed 40mm/s
Nozzle Temp: 235°
Bed Temp: 70°
Infill: 25%
4mm Brim
| 发表的日期 | 18/07/2019 |