Stand consists of

1x Stand

1x Diffuser

1x Lid

1x m3 12mm bolt and nut

2x 3 LED light strips https://www.jaycar.com.au/low-cost-5m-flexible-adhesive-led-strip-lights/p/ZD0575

1x 9v battery snap https://www.jaycar.com.au/9v-battery-snap-high-quality/p/PH9232
and some wire.

1x  Switch https://www.jaycar.com.au/sub-miniature-dpdt-panel-mount-switch/p/SS0812

All parts are sourced locally from jaycar Australia ,

I have support enabled just for the top outer edge of the enclosure as well as under the tabs on the lid.

The frame and lid print in about 5 hours, and the diffuser takes about 1 hour

 The design was inspired by https://www.thingiverse.com/thing:2851459
 though completely redesigned in fusion to suite my needs.