Makers Modular Mask System - Low Poly Covid-19 Face Mask Respirator - 3D Printed for Corona Virus and other Applications
Makers Modular Mask System - Low Poly Covid-19 Face Mask Respirator - 3D Printed for Corona Virus and other Applications
Published 2020-04-16T18:40:14+00:00
If you like this mask and would like to help support my work you can either use the "Tip Designer" link or PayPal me directly at:
https://www.paypal.me/MrDWGraf
The Goal of this mask is to make a low poly respirator that is stupid simple to print/operate and that uses a readily available/incredibly cheap filter mechanism requiring no cutting of material. (in this case makeup pads)
This mask is a low poly option (Lite Large Mask with Lite filter 21g see Thingiverse link below) that requires no supports, rims or rafts and can be printed at 0% infill. Using minimal filament allows the mask to print much quicker/cheaper in a situation where mass production is necessary.
For more sizes, models (including the 21g lite model) and for the Dual Filter Adapter, visit my Thingiverse site for this mask at https://www.thingiverse.com/thing:4256244
Thanks!!
Note I recommend a flexible filament if you are able. as I've said before, putting PLA on your face could be risky in the event that you get hit in the face. It could break and cause injury. Of course, if all you have is PLA then you need to decide if the risk of Corona is worse. I will leave it up to you to decide if the risk is worth it.
发表的日期 | 16/04/2020 |
支持自定义 | YES |
sry for the mess :P Printed on a Zonestar Z6