Please enter the code below
Another Top Design
This design uses a marble as the point. Any glass marble or steel ball (15 mm - 17.5 mm) will work. If your marble/ball is too lose just put paper or craft foam between the marble/ball and the stem (I had to use a piece of paper).
Designed using Fusion360.
Printed on my Anet A8, using .2 mm layer height, 20% infill, 3 perimeters, 3 top layers, and 3 bottom layers.
Stem took 68 min to print (30mm x 20mm & 3.5g PLA)
Top took 3 hr 16 min to print (120mm x 19.25mm with marble (21mm without) & 31.5g PLA)