Minimalistic spice rack (customizable)
2,065
views
103
downloads
2
collections
0 comments
Loading comments... 
Minimalistic spice rack (customizable)
3D
Published 2020-03-24T22:55:29+00:00
45
0
Add to Collection
Description
Some presets have already been generated, but you can tune it at the customizer. To make it, you will need:
- Wooden sticks: found at any department or hardware store, the ones I used are 30cm of length and 25mm of radius. When customising the model, I set the radius to 26.5mm for a tight assembly. If you are not sure, print it with a smaller radius and open it a bit with the tip of a blade/scissors, it is easier than glueing loose sticks.
- Mounting tape: If you don't find a strong one like this or this, you can customize the model to increase the mounting surface. You can test if it holds properly to the wall by sticking a stand full of spices close to the floor for a day.
It has been extensively tested: I printed ~10 different versions to ensure that the weight is properly distributed among the wooden sticks and can hold 3kg of spices on each stand. Six regular spice bottles should not weight more than 300g, so this will hold even if you cook with osmium.
允许
Technical Information
| 发表的日期 | 24/03/2020 |
More Information
Object Parts