Swole Y-Idler Tensioner
Swole Y-Idler Tensioner
Published 2017-10-09T11:51:07+00:00
This is a replacement for weak original y-idler. Mine broke during assembly because I am a tiny bald gorilla. Went overboard with strength but if you like that kind of thing, this may be a good upgrade for you.
Hardware sourced from Prusa Research extras bag.
x4 M3 x 20mm
x3 M3 x 25mm
x4 M3 washer
x1 M3 Nyloc nut (from original part)
x6 M3 square nut
x2 M8 low-profile nut
x2 M8 washer
optional GT2 20T 3mm Idler Pulley
As of revision 3A, idler can be attached without dissasembly of frame. Has clearance for idler nut.
My print was in Prusa Orange PETG sliced on Slic3r Prus Edition 1.4. As PETG is a difficult material to tune, below details are offered only as reference.
0.2mm layer height
3, 11, 11 (perimeter, top, bottom)
Ensure vertial Off
Avoid crossing On
Detect bridging On
Infill default 50% Cubic
No support
40 mm/s Perimeter
20 mm/s Bridges
150 mm/s Travel
15 mm/s First layer
0.2mm Elephant foot compensation
- - -
235°C Extruder
100/80°C Bed (First/Others)
- - -
Use your own tuned K value.
Please tune your extrusion or multiplier correctly for PETG.
- - -
Fill modifier is optional.
100% Infill
Pattern Rectilinear
发表的日期 | 09/10/2017 |
让时间去下载 | - 382 分钟 |
材料数量 | 40.4 g |
尺寸大小 | 70.10 x 88.63 x 20.50 mm |
打印工艺 | FDM |
复杂程度 | 容易 |
支持自定义 | YES |