Monster Hunter Insect Glaive
- COSPLAY>
- 冷兵器 |
- 同人作品>
- Monster Hunter
Monster Hunter Insect Glaive
3D
Published 2017-02-21T10:05:57+00:00
This is a full sized re-imagined, Monster Hunter insect Glaive.
Its Designed to print on my little Cel-robox so apologies for the many pieces to this one. Im sure you could combine pieces if you have a bigger printer. For the most part no supports are needed other than for the sword which i printed the pieces standing up but in hindsight may have been better printed flat.
There is a hole down the middle so you can put a pole down it for some strength if you wish. I had a carbon fiber window cleaning pole laying around so its made to fit that.
There is also enought space in the crystal at the end to mount some LEDs for some extra effect.
The real heavy printing parts are the rock and dragon head so keep the infill as low as you can on those.
its taken me a week to print all the parts so far and im not done yet!! So be ready to have your printer tied up for a while.
i would like to adjust the dragon head size at a later date as it comes up rather large in real life, the comp deadline is upon me however so thats a project for another day/week.
| 发表的日期 | 21/02/2017 |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |